Videoswitch VDM User Manual download pdf (Page 53)

Videoswitch VDM Digital Recorder

Vdm601t.doc 45

10.4.7.2 Remote Password

A password may be set to prevent unauthorised remote access. Set to all zeros if the revision of remote

access software (“VI-Connect”) used does not support password protection.

10.4.7.3 Remote Covert Cameras

Cameras may each be set as visible or hidden (covert) when accessed remotely via PSTN or ISDN. Note

that only cameras that are currently recording may be viewed live.

10.4.7.4 Network Settings

10.4.7.4.1 Network Interface

The setting of this option depends on whether or not there is a remote access module is fitted into the rear of

the VDM.

• If a VDM-PSTN module is fitted, select “PSTN”

• If a VDM-ISDN module is fitted, select “ISDN”

• If a VDM-ETHERNET module is fitted, select “ETHERNET”

• If no option modules are fitted, select “RS232” (factory default).

10.4.7.4.2 IP Address

If the Ethernet option module is being used, enter a valid IP Address here. The address is entered using the

camera keys 1..9 for numbers 1 to 9, camera key 10 for zero, and camera key 11 for a dot.

Alternatively, press the DEFAULT key to default the address to:

192.168.16.50

In order to view images on a PC, the software “Vi-connect” must be installed, and the IP address must be

entered as part of the “site” information for this VDM.

If a PSTN or ISDN option module is being used, the address may be used for a telephone number for testing

the ISDN or PSTN connection. Press ALT and

to select the modem monitoring mode. Make sure that

“CTS” is displayed (not BSY), then press ALT and

to dial or end a call.

If you have a PSTN option module, you can enter the number of a telephone, and can check that the phone

rings to test the PSTN line. Press ALT and

again to terminate the call. Press ALT and again to exit

the modem monitoring mode

10.4.7.4.3 Sub-Net Mask

The Sub-Net Mask may be set in the same manner as the IP Address.

10.4.7.4.4 Gateway

The Gateway may be set in the same manner as the IP Address.

10.4.7.4.5 Port

If the Ethernet option module is being used, enter a valid Port number. The port number is entered using the

camera keys 1..9 for numbers 1 to 9 and camera key 10 for zero.

Alternatively, press the DEFAULT key to default the port number to:

9221

In order to view images on a PC, the software “Vi-connect” must be installed, and the port number must be

entered as part of the “site” information for this VDM.

10.4.7.4.6 PSTN Rings

This determines how may rings occur before the PSTN modem (if fitted) answers an incoming call.

10.4.7.4.7 ISDN Answer Mode

The ISDN answer mode may be set to:

• Normal – An incoming ISDN call will always be answered if it is of the correct type (i.e. V120)

• Sub-Address – If this option is set, an incoming call will only be answered if it is of the correct type

(i.e. V120) and a sub address is specified from the calling end which matches the “ISDN MSN/Sub-

Address” (section 10.4.7.4.8).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 64 65

Comments to this Manuals

No comments

Videoswitch VDM User Manual Page 53

Comments to this Manuals

Related products and manuals for Recorders Videoswitch VDM