Videoswitch Vi200 User Manual download pdf (Page 44)

Digital Recorder

14 Technical Data

14.1 Power-On Reset

If you wish to perform a power-on-reset to restore all settings to their factory defaults, press

the DEF key while you apply power, and keep pressing it until the Vi200 has powered up

and displays

FACTORY RESET

. Note that this process will reset all user settings, including

camera titles. The

DEF

key will need to be pressed for about 10 seconds.

The factory configuration can also be recalled via the menu (see section 9.6.4).

14.2 Accessories Included

 Vi200

 Mains Cable

 Vi-X1 Alarm Break-out module

 Hard Drive Key

 Manual

 CAT5 Ethernet Cable

 Blank CDs (2)

14.3 Changing the Hard Drive

Hard drives are sensitive mechanical devices that may be damaged by shock or vibration.

Always protect them from shock and vibration when transporting.

Remove power from the Vi200 before removing the hard drive. Wait for 30 seconds for the

drive to stop spinning

before moving the Vi200 or removing the hard drive. Moving a drive

that is still spinning can damage it.

The hard drive drawers require a special key to unlock them. This is supplied with the Vi200.

Insert the key, and turn it clockwise to unlock the drive.

To put a hard drive back into the Vi200, make sure that the lock in the drive drawer is in the

unlocked position. Carefully slide the drawer in as far as it can go with the handle in the up

position. Carefully push the handle down such that the drawer is pulled into the drive bay.

When it is properly located, lock the drawer by turning the key counter-clockwise.

After changing a drive, re-apply power to the Vi200.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 54 55

No comments

Videoswitch Vi200 User Manual Page 44